Home/MIDI Control

How setup your AIRTURN MIDI pedal with Quantiloop

The instructions below apply to the BT200-S series. However simular procedures apply to other AIRTURN MIDI capable pedals. For detailed instructions operating your specific pedal please check your pedal’s manual. To connect the pedal with Quantiloop: Power on the AIRTURN Be sure that the AIRTURN is in Mode 7 (Hold down the mode button for [...]

By |2019-04-02T05:35:28+00:00April 2nd, 2019||0 Comments

I don’t have a MIDI controller yet, can you give me some advice

There are many MIDI controllers on the market and your choice depends on your preference. MIDI controllers that are known to work with Quantiloop are: IRIG Blueboard Behringer FCB1010 Positive Grid BT-4 (Latching Only!!) Line 6 FBV3 Line 6 Helix Softstep and most other controllers. For wireless control the IRIG blueboard is our favourite. The [...]

By |2017-02-16T19:54:25+00:00October 21st, 2016||0 Comments

How do I setup a Positive Grid BT-4 for use with Quantiloop

The Positive Grid BT-4 unfortunately does not support momentary operation at this moments. To setup follow the instructions in: Is my MIDI controller 'XYZ' supported by Quantiloop The limitation is that hold actions can not be assigned to any of the buttons. This is not a Quantiloop limitation, but requires momentary operation from the controller. [...]

By |2016-10-21T17:14:08+00:00October 21st, 2016||Comments Off on How do I setup a Positive Grid BT-4 for use with Quantiloop

Is my MIDI controller ‘XYZ’ supported by Quantiloop

Quantiloop supports all MIDI controllers that are compatible with iOS, as long as it can send either CC or Note messages (as of version 1.1). Note that PC messages are not supported for loop controls as they don't give an optimal experience. (PC messages may be used for preset changing though).  However most if not all MIDI controls [...]

By |2017-02-16T20:04:34+00:00October 21st, 2016||Comments Off on Is my MIDI controller ‘XYZ’ supported by Quantiloop

How do I setup my iRIG Blueboard with Quantiloop

For optimal experience with Quantiloop, your IRIG Blueboard has to have firmare 1.2 or higher installed. As of firmware 1.2 the Blueboard supports Apple Bluetooth over LE and momentary control change behavior. There is no need for the IRIG BlueBoard software in this case. First ensure that you are on the right firmware. (Firmware download is available [...]

By |2016-10-21T17:16:21+00:00October 21st, 2016||Comments Off on How do I setup my iRIG Blueboard with Quantiloop
Go to Top